Searching for wire connectors on large trigger zones
complete
A
Alan
It can be difficult to find the wiring connectors on large trigger zones. Unless the zones are scaled, the connectors remain the same size and there is nothing to indicate which side of the zone the connectors are on or where. For very large trigger zones, it can involve a bit of a search which can be a bit inconvenient.
How about adding an 'X' to the side of the trigger zone where the connectors are located, where the center of the 'X' is the location of the connectors. The X resizes with the trigger zone.
Joker
complete
Output pins now scale with Trigger Volumes to make them easier to find and use [|=)]
Meriesa
in progress
123456789
It is always in between the two sides that connect to the corner, it will be on either one. Hope this helps.
Ralziel
Yeah this bothered me a bit yesterday. I found a workaround by wiring the zone to its target, then scaling the zone up. Not ideal in all situations though.